Water heater pilot light out in Round Rock, TX

Send the request today and let a water heater pro reach out to you.

Hand it over

A pilot light that won't stay lit usually comes down to one of a few things: a thermocouple that's worn out and no longer sensing the flame, a draft from a vent or nearby door pulling the flame out, or dirt and soot blocking the pilot opening itself. Sometimes it's a gas valve that's failing. Water heaters in Round Rock don't get a break from hard use. Winters here are mild, but most homes rely on electricity for heat, which means the water heater is one of the few gas appliances running steadily through the year, and that steady use wears on a thermocouple over time. If you've tried relighting it following the label instructions and it won't hold, or it lights and goes out within seconds, the part sensing the flame is likely the problem, not something you did wrong. Until it's fixed, there's no hot water, and depending on the unit, a gas valve left trying to ignite without success can be a safety concern worth having checked soon.

A large gray cylindrical gas water heater stands in a concrete-walled basement corner, connected to copper and black pipes and a metal flue, with ductwork at left.

Pilot Lit and Holding

When the pilot catches and stays lit, the thermocouple is doing its job, sensing the flame and keeping the gas valve open. You'll see a steady blue flame through the sight glass and hot water within a normal wait. The burner fires when the thermostat calls for it, nothing more to do.

A gray cylindrical water heater with two access panels and copper piping stands in the corner of a concrete-walled basement next to exposed pink insulation.

Pilot Won't Stay Lit

A pilot that goes out as soon as you let go of the gas control usually means the thermocouple has worn out. Soot around the pilot opening or a draft reaching the burner chamber can cause the same thing. Rust staining on an older tank is worth noting too, since it points to a unit nearing the end of its life.

A smiling bearded man in a dark long-sleeved shirt sits on a brown leather sofa in a living room, with a large glass bowl of popcorn on a table in the foreground and a houseplant and doorway behind him.
A smiling man with gray-streaked hair and a beard in a dark blue sweater reclines on a sofa in a living room with a lit wood stove, shelves, wicker baskets and a bowl of popcorn on a table.
A smiling bearded man in a dark plaid shirt sits on a green couch beside a cushion and a wooden bowl of popcorn, with a blurred kitchen and living area behind him.
A smiling bearded man in a dark green henley shirt sits on a gray couch in a living room with a bookshelf, lit lamp, houseplant and framed picture behind him, and a bowl of popcorn in the foreground.

Why the Thermocouple Fails First

The thermocouple sits right in the pilot flame, and that's its job: a small rod that reads heat and tells the gas valve it's safe to stay open. Years of that flame pass over the same spot, and the metal tip wears down until it can't send a strong enough signal anymore. The valve reads that as no flame at all, even with the pilot lit in front of you, and shuts the gas off. It's a wear part, not a defect, which is why relighting it twice or three times without it holding points to the thermocouple itself rather than something you did wrong lighting it.

What a Blocked Pilot Looks Like

Dirt and soot build up slowly inside the small tube that feeds gas to the pilot, and the flame changes shape before it goes out for good. Instead of a steady blue cone, you'll see it lean to one side, sputter, or burn yellow and small. That's the opening narrowing, not enough gas getting through to hold a flame against any draft at all. A vent that's partly blocked outside, or a water heater closet door that doesn't seal well, can finish the job on a flame that's already struggling. Clean the area around the pilot and check outside vents are clear before assuming the part has failed.

A gray cylindrical water heater with copper piping stands against a concrete basement wall beside a white vertical pipe and a wooden post.
Before you get your water heater repair
A gray cylindrical water heater stands against a concrete basement wall, connected to copper pipes and a metal flue overhead, with a white discharge pipe running down its right side and exposed wood framing to the right.
After you get your water heater repair

No hot water

A pilot that won't hold means no hot water for showers, dishes or laundry until it's relit and stays lit. If it keeps going out, that's a part failing, not bad luck.

Hand off my repair

Gas smell or soot

A pilot acting up can come with a faint gas odor near the valve or soot around the burner. Either one is worth having a contractor look at before you try relighting it again.

Hand off my repair
A woman in a cream knit sweater reclines on a sofa with her eyes closed and a slight smile, a closed dark book resting on a blanket in the foreground and a lit lamp and small potted plant behind her.
A smiling bearded man in a dark green sweater sits at a dinner table with a glass of red wine, a bowl of salad and a lit candle in the foreground, in a dimly lit room with a framed picture, lamp and potted plants behind him.

Power here costs 13.97 cents per kilowatt-hour

Most homes in Williamson County run their water heater on gas, but the glow plug, blower or control board still pull electricity, so a dead pilot doesn't always mean a cheap fix waits on the other end. At 13.97 cents a kilowatt-hour, a tech sorting out the real cause before relighting it saves you from paying to fix the same problem twice.

EIA-861 2025

A white cylindrical water heater with copper piping stands in a dim concrete basement, with a pool of water spread across the floor around its base.

It's a Saturday morning in Round Rock, and you're down in the garage next to the tank, lighter in hand for the third time. The pilot catches, holds for a few seconds, then dies again. No hot water, and your daughter's waiting on a shower before soccer. You crouch down, squint at the sight glass, try to see if the flame's even touching the thermocouple right. It isn't your fault and it isn't going to fix itself from here. You wipe your hands on your jeans and think about how many contractors you'd have to call before one picks up on a weekend, how many times you'd have to describe this same thing over the phone.

Hand off the water heater problem

Describe what your water heater is doing once, in one form.

No charge to send it. You decide if you hire them.

Relighting It Yourself

The instructions are usually printed right on the tank, and for a pilot that just blew out once, that's often enough. You hold the knob, light the pilot, wait for it to catch, and let go slow so the thermocouple has time to sense the flame. If it holds, you're done. But if you're back doing this again next week, or it won't hold past a few seconds no matter how many times you try, relighting it isn't fixing anything. It's just buying a few hours before the water goes cold again.

Having It Diagnosed

A tech checks the thermocouple with a meter instead of guessing from how the flame looks, and traces whether a draft or a blocked pilot opening is the real cause before anything gets replaced. That matters more once a gas smell or soot shows up, since those point past the pilot to the burner or venting. Instead of relighting the same pilot on repeat, you find out which part failed and why, and get it put back together so it holds for good, not just for tonight.

Who's waiting on this water heater to get fixed?

  • 2.65 people per household on average

    Williamson County households run 2.65 people on average, so a dead pilot usually means more than one person going without hot water.

  • Half the homes here were built by 2006

    Half the homes here were built in 2006 or earlier, old enough that the thermocouple or gas valve may never have been swapped out.

  • 50% of homes heat with electricity

    Electricity heats half the homes in this county, but yours runs on gas, which means a pilot and thermocouple instead of a heating element.

ACS 2020-2024

A closed silver laptop and a light ceramic mug of dark coffee sit on a wooden table, with a window showing a sunset at left and a kitchen counter with a cutting board and potted plant in the background.

A pilot that won't hold is a part failing, not bad luck

A worn thermocouple, a draft finding its way to the flame, or soot sitting in the pilot opening. That's the short list, and sorting out which one it is takes someone looking at the tank, not guessing from across the garage.

Right now that probably means a few calls, explaining the same thing to each one, then sitting with quotes trying to tell them apart with no hot water waiting on the other end. Send the form once and that part is done. A licensed contractor in Round Rock takes it from there, and you go back to waiting on the fix instead of waiting on someone to call you back.

Interior corner of a living room with a sheer-curtained window, a light wood console table holding a vase of greenery and a shallow bowl, a woven basket on the lower shelf, and a blurred upholstered sofa and dark wood table in the foreground.
A gray cylindrical water heater with copper pipes stands against a plain concrete wall in a dim basement with a concrete floor, a staircase at left and concrete block wall at right.

Finding a pro stops being your job

Skip calling shops to ask who repairs water heaters in Williamson County.

Step 1 of 3: Equipment